Delta 50-840 Connecting Machine To Power Source, B L O W E R Assembly, Power Connections

ASSEMBLING DUST INTA K E H O S E TO M O TO R A N D

B L O W E R ASSEMBLY

The dust collector is supplied with a 4 flexible dust intake hose.

To assemble the dust collection hose to the motor and blower assembly, loosely attach hose clamp (A) Fig. 14, around one end of flexible hose (B) and assemble the hose to dust intake port (C). Tighten hose clamp (A) Fig. 15, to hold flexible hose (B) on the blower and motor assembly (D). Assemble the remaining clamp to the other end of the flexible hose and to the woodworking machine. IMPORTANT:Do not operate the dust collector without the flexible hose assembled to the dust intake port.

Always disconnect dust collector from the power source before connecting or disconnecting an air intake hose to or from the blower and motor assembly.

A

C

B

Fig. 14

A

B

D

Fig. 15

CONNECTING MACHINE TO POWER SOURCE

POWER CONNECTIONS

A separate electrical circuit should be used for your tools. This circuit should not be less than #12 AWG and should be protected with a 20 amp, time lag fuse. Have a certified electrician repair or replace damaged or worn cord immed- iately.Before connecting the motor to the power line, make certain the switch is in the OFF position and be sure that the electric current is of the same characteristics as stamped on the motor nameplate. All line connections should make good contact. Running on low voltage will damage the motor.

W ARNING: D O NOT EXPOSE THE DUST COLLECTO R TO RAIN O R OPERATE THE MACHINE IN DAMP LOCATIONS.

M O TO R SPECIFICATIONS

The motor of the Model 50-840 Dust Collector is shipped wired for 120 Volts. Before connecting the dust collector to the power source, make certain the switch is in the OFF position.

GROUNDING INSTRUCTIONS

WARNING: THIS TO O L M U S T B E G R O U N D E D WHILE IN USE TO PROTECT THE OPERATO R F R O M ELECTRIC SHOCK.

This dust collector must be grounded. If it should malfunction or break down, grounding provides a path of least resis- tance for electric current to reduce the risk of electric shock. This dust collector is equipped with a cord having an equip- ment-grounding conductor and grounding plug. The plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

WARNING: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the dust collector. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.

9