Delta 78-939 manual Assembly, For Biesemeyer Commercial Or Home Shop Fences Only

ASSEMBLY

DISCONNECT SAW FROM POWER SOURCE UNTIL ALL ASSEMBLY AND SET-UP PROCEDURES HAVE BEEN COMPLETED.

FOR BIESEMEYER® COMMERCIAL OR HOME SHOP FENCES ONLY.

1.Fold template (A) Fig. 2, on fold line and align the template with the bottom of fence board (B). Using a punch, mark the fence board (B) as indicated on the template (A) for Commercial or Home Shop installation. Then proceed to section “FOR ALL FENCES” STEP 8.

FOR BRANDS OTHER THAN BIESEMEYER

2.Place cut-off support (C) Fig. 3, onto saw fence (D) as shown.

3.Place a straight edge (E) Fig. 3, approximately 1/16”- 1/8” thick, onto saw table as shown. Then, place cut-off fence board (F) Figs. 3 and 4, vertically onto straight edge (E) and against saw fence (D) with the unfinished edge down as shown in fig. 4.

4.Hold cut-off fence board (F) Fig. 4, Firmly against cut-off fence support (C), and draw a line across the rear of cut-off fence board (F) as shown.

5.Remove cut-off fence board (F) Fig. 4, and cut-off fence support (C) from saw fence (D), and place cut-off fence board onto a flat, supporting surface with pencil marks facing up as shown in Fig. 5.

6.Align the top of cut-off fence support (C) Fig. 5, with the pencil line on cut-off fence board (F) and center cut-off fence support (C) onto board.

7.Using a pencil, mark the back of cut-off fence board (F) Fig. 5, through the two holes (G) in cut-off fence support

(C).

A

B

Fig. 2

D

E

	C
	F
	Fig. 3
D	C
	F

E

Fig. 4

C

GF

Fig. 5

2