ADJUSTING UPPER BLADE GUIDES AND BLADE SUPPORT BEARING
IMPORTANT: BOTH THE UPPER AND LOWER BLADE GUIDES MUST BE PROPERLY ADJUSTED TO PREVENT THE BLADE FROM TWISTING DURING OPERATION.
DISCONNECT MACHINE FROM POWER SOURCE.
UPPER BLADE GUARD (B) FIG. 27 IS SHOWN REMOVED FOR CLARITY. ALWAYS MAKE SURE THE UPPER BLADE GUARD IS INSTALLED AND PROPERLY ADJUSTED BEFORE OPERATING THE BAND SAW.
1.Loosen the two screws (C) Fig. 27, and adjust the blade guides (D) as close as possible to the sides of the saw blade, being careful not to pinch the blade. Tighten the two screws (C).
2.Loosen screw (E) Fig. 27, and move the guide bracket (F) in or out until the front edge of the guides (D) are just behind the “gullets” of the blade teeth. Tighten screw (E).
3.The upper blade support thrust bearing (G) Fig. 27 prevents the saw blade from being pushed back too far when cutting. The support bearing (G) should be adjusted approximately 1/32" behind the blade. The blade should also overlap the outside diameter of the ball bearing by approximately 1/8". To adjust:
4.Loosen screw (H) Fig. 28, and slide support bearing
(G) in or out until it is approximately 1/32" behind the saw blade.
5.The upper blade support bearing (G) Fig. 27, is set on an eccentric shaft. To change position of bearing (G), use a straight screwdriver, rotate shaft (J) Fig. 28, until the blade properly overlaps the support bearing. Then tighten screw (H).
GH
FE
B
C
DC
Fig. 27
J
H
Fig. 28
14
