ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
STAND ASSEMBLY
1.Assemble stand as shown in Fig. 4, using parts shown in Fig. 3. The brackets and legs are identified with the same letter in both illustrations. Insert the M8 x 16mm carriage head screws through the legs and the brackets then place the 3/8" flat washers on the screws and secure with the M8 hex nuts. Only tighten nuts
2.Attach the four plastic feet (1) Fig. 4 to the bottom of each leg (L).
BAND SAW TO STAND
ASSEMBLY
1.Fig. 5 illustrates the four through holes (A) which will be used to secure the band saw to the stand.
A | B |
| |
| L |
| E |
| C |
1
Fig. 4
A
A
Fig. 5
2.Place the band saw on top of the stand and line up the holes (A) Fig. 5 with the holes (D) Fig. 6 on the top brackets of the stand.
D D
Fig. 6
8