Delta SH100 FASTENING ROUTER/SHAPER TO SUPPORTING SURFACE, OPERATING CONTROLS AND ADJUSTMENTS

The table insert (A) is assembled in the table, as shown

in Fig. 11.

Fig. 11

FASTENING

IF DURING OPERATION THERE IS ANY TENDENCY

FOR THE ROUTER/SHAPER TO TIP OVER, SLIDE OR

WALK ON THE SUPPORTING SURFACE, THE

ROUTER/SHAPER SHOULD BE SECURED TO THE

SUPPORTING SURFACE. REMOVE THE FOUR

RUBBER FEET ATTACHED TO THE ROUTER/SHAPER,

AND FASTENING THE MACHINE TO THE SUPPORTING

SURFACE WITH FASTENERS (not supplied).

IF YOU PURCHASED THE ACCESSORY STAND, THE

FOUR PLASTIC FEET, SUPPLIED WITH THE STAND,

FEATURE HOLES WHICH ALLOW THE STAND TO BE

SECURED TO A SUPPORTING SURFACE WITH

FASTENERS (not supplied).

The on/off switch (A) Fig. 14, is located on the front of the

Router/Shaper cabinet. To turn the machine “ON,” move

the switch (A), up to the “ON” position. To turn the

machine “OFF,” move the switch (A), down to the “OFF”

position.

IMPORTANT: When the machine is not in use, the switch

should be locked in the “OFF” position to prevent

unauthorized use. This can be done by grasping the

switch toggle (B) Fig. 15, and pulling it out of the switch

as shown. With the switch toggle (B) removed, the switch

will not operate. However, should the switch toggle be

removed while the machine is running, it can be turned

“OFF” once, but cannot be restarted without inserting

the switch toggle (B).

Fig. 14

Fig. 15