Delta TE-2000 PGM, 10. Tax table programming (continued…), Enter tax rate (2 integers and 4 decimals), Enter rounding method, tax calculation method, Programming procedure

Getting Started

10. Tax table programming (continued…)

Programming tax calculations (with special rounding)

Prepare the following subjects:

1.Tax rates

2.Rounding method for tax calculation (Round up/Round off/Cut off)

3.Tax calculation system (No/Add-on/Add-in)

4.Rounding system (Special rounding 1/Special rounding 2/Special rounding 3/Danish rounding /Australian rounding) :only effective for Tax Table 1

CAL	X
Programming procedure	Z
REG
OFF
RF	C
PGM	-A32

PGM

								Mode Switch
							4
									3s
							4
Assign tax table 1. .................................................................................			6				0125s
Assigning tax table 2, enter 0225.
Assigning tax table 3, enter 0325.
Assigning tax table 4, enter 0425.
Enter tax rate (2 integers and 4 decimals)							4
Example: 15% = 15
8.25% = 8^25
	non tax = 0
	................................................................					6 : : : : : :a
Enter rounding method, tax calculation method..							4
									0a
	Fraction round up	9	0
							4
	Fraction round off	5	0
	Fraction cut off	0	0
	Special rounding 1 *			1
	Special rounding 2 *			2
	Special rounding 3 *			6
	Special rounding 4 *			3
	Special rounding 5 *			7
	Add-on tax				2
	Add-in tax				3
	* See the next page.						D4 D3 D2 D1
	...................................................................................					6 : : : :a
							4
Terminate the procedure. .......................................................................			6							s

E14