ENGLISH
Troubleshooting Information Playback Setup Connections Started Getting
Troubleshooting
If a problem should arise, first check the following:
1.Are the connections correct?
2.Is the set being operated as described in the owner’s manual?
3.Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase.
GGeneralHSymptom | Cause | Countermeasure | Page |
No sound is produced. | • The iPod is not playing. | • Check that the iPod is playing. | – |
No image appears on the | • The iPod is not properly connected to the | • Check that the iPod is properly connected to the | – |
monitor. |
| dock connector. | 7 |
| • The AC adapter is not connected to the | • Check the connections. | |
| outlet. |
| 7 |
| • The AV/Control cable is not properly connected. | • Check the connections. | |
| • The monitor’s input selection is not properly set. | • Set the monitor’s input selector to the proper position for | 7 |
|
| the connected video input terminal. |
|
Symptom | Cause | Countermeasure | Page |
Set does not work | • Batteries are worn. | • Replace with new batteries. | 3 |
properly when remote | • You are operating outside of the specified range. | • Operate within the specified range. | 3 |
control unit operated. | • Obstacle between main unit and remote control unit. | • Remove the obstacle. | 3 |
| • The batteries are not inserted in the proper direction, | • Insert the batteries in the proper direction, following the | 3 |
| as indicated by the polarity marks in the battery | polarity marks in the battery compartment. |
|
| compartment. |
| 3 |
| • The set’s remote control sensor is exposed to strong light | • Move the set to a place in which the remote control sensor | |
| (direct sunlight, inverter type fluorescent bulb light, etc.). | will not be exposed to strong light. |
|
25