ENGLISH

4

Set the surround parameter according to the source.

 

First, press the SURROUND PARAMETER button.

 

 

NOTE: Please make sure the “AUDIO” position of the slide switch on the remote

(Remote control unit)

control unit.

 

 

 

5

Use the

(left) and

(right) buttons to set the CINEMA EQ.

 

 

 

 

 

(Initial)

 

 

CINEMA EQ OFF

OFF

ON

(Remote control unit)

 

 

 

 

 

 

 

 

 

 

(left) button

(right) button

 

Press the SURROUND PARAMETER or

(down) button to switch to the D.

(Remote control unit)

COMP. setting.

 

 

 

 

 

 

 

 

Surround parameters w

CINEMA EQ. (Cinema Equalizer):

The Cinema EQ function gently decreases the level of the extreme high frequencies, compensating for overly-bright sounding motion picture soundtracks. Select this function if the sound from the front speakers is too bright.

This function only works in the Dolby Pro Logic, Dolby Digital and DTS Surround modes.

D.COMP. (Dynamic Range Compression):

Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud sounds). For listening late at night, or whenever the maximum sound level is lower than usual, the Dynamic Range Compression allows you to hear all of the sounds in the soundtrack (but with reduced dynamic range). (This only works when playing program sources recorded in Dolby Digital.) Select one of the four parameters (“OFF”, “LOW”, “MID” (middle) or “HI” (high)). Set to OFF for normal listening.

LFE (Low Frequency Effect): Program source and adjustment range

1.Dolby Digital: –10 dB to 0 dB

2.DTS Surround: –10 dB to 0 dB

When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct Dolby Digital playback.

6

(Remote control unit)

(Remote control unit)

Use the (left) and (right) buttons to set the D. COMP. (Initial)

OFF LOW

MID HI

D.COMP. OFF

 

(left) button

(right) button

Press the SURROUND PARAMETER or (down) button to switch to the LFE setting.

NOTE: This parameter is not displayed during DTS playback.

When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback.

When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to -10 dB for correct DTS playback.

7

Use the

(left) and

(right) buttons to set the LFE level.

 

LFE 0dB

(Remote control unit)

• The level can be adjusted in units of 1 dB from –10 to 0 dB.

Set to the desired level according to the speaker systems being used and the source to be played.

(Remote control unit)

Press the SURROUND PARAMETER or

(down) button to switch to the

 

default setting.

 

8

To reset the settings to the factory defaults, use the (left) and (right) to display “Yes”.

(Remote control unit)

DEFAULT Y/N

YES Y/N NO

(Remote control unit)

(left) button (right) button

Press the SURROUND PARAMETER or (down) button to switch to the CINEMA EQ. setting.

9

Press the ENTER button to finish surround parameter mode.

 

 

(Remote control unit)

20