ENGLISH

TP search

Use this function to find RDS stations broadcasting traffic program (TP stations)

1

Set the input source to “TUNER”.

1

3 2

 

 

(Main unit)

(Remote control unit)

 

 

16LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

•The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit’s power operation switch is off and with the power cord disconnected.

17INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable

2

Press the RDS button until “TP

SEARCH” appears on the display.

 

(Main unit)

3

Press the PRESET UP or DOWN button TP

search begins.

(Main unit)

(Remote control unit)

If no TP station is found with above operation, all the reception bands are searched.

4

The station name is displayed on the display after

searching stops.

5

To continue searching, repeat step 3.

If no other TP station is found when all the

frequencies are searched, “NO PROGRAMME” is displayed.

RT (Radio Text)

“RT” appears on the display when radio text data is received.

When the RT button is pressed while receiving an RDS broadcast station, the text data broadcast from the station is displayed. To turn the display off, press the RT button again. If no text data is being broadcast, “NO TEXT DATA” is displayed.

1

3

‘‘ RT’’

result, the initialization of the microprocessor is required by the following procedure.

 

 

1

Switch off the unit using the main unit’s power

 

 

operation switch.

 

 

2

Hold the following SPEAKER A button and B

 

 

button, and turn the main unit’s power operation

 

 

 

switch on.

1, 2

2

3

Check that the entire display is flashing with an

 

 

interval of about 1 second, and release your fingers

 

 

 

from the 2 buttons and the microprocessor will

 

 

 

be initialized.

 

 

NOTES:

 

 

• If step 3 does not work, start over from step 1.

 

 

• If the microprocessor has been reset, all the

 

 

 

button settings are reset to the default values

 

 

 

(the values set upon shipment from the factory).

Turning on the main unit’s power from the standby mode without using the remote control unit

•Press the power switch on the main unit while pressing the INPUT MODE button on the main unit’s panel to turn on the power.

26