Denon DCD-CX3 Troubleshooting, Using the Timer Play Function, 5Turn the timer “ON”, 3Load a disc in the player, 4Set the audio timer for the desired times

ENGLISH

Getting	Using the Timer Play Function
	Also refer to the operating instructions of the audio timer.
Started	DCD-CX3 (This unit)
Connections
Operations	Receiver
Troubleshooting	AC outlet (wall)
Specifications	Audio timer

1Turn on the power of the connected components.

2Switch the receiver’s input function to the function to which the player is connected.

3Load a disc in the player.4Set the audio timer for the desired times.5Turn the timer “ON”.

The power of the components connected to the timer turns off.

b When the set time is reached, the power of the different components automatically turns on and playback starts from the first track.

Troubleshooting

If a problem should arise, first check the following:

1.Are the connections correct ?

2.Is the set being operated as described in the operating instructions ?

3.Are the other components operating properly ?

If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase.

Symptom		Cause		Measures	Page
Disc tray does not open.	• The power is not on.			• Turn on the power.	8
“NO DISC” is displayed even	• The disc is not properly loaded.			• Reload the disc.	3
though a disc is loaded.
“00 : 00” is displayed even	• A disc other than a CD or Super Audio CD			• Load a CD or Super Audio CD.	3
though a disc is loaded.	is loaded.
Playback does not start even when	• The disc is dirty or scratched.			• Wipe the dirt off the disc or replace the	3
the 1/3 button on the main unit				disc.
or the 1 button on the remote
control unit is pressed.
No sound is produced or sound is	• The	output cables are	not properly	• Check the connections.	7
distorted.	connected to the receiver.
	• The	receiver’s function	setting or	• Check the receiver’s function and controls	–
	adjustments are not right.			and adjust as necessary.
No digital signals are output.	• For Super Audio CDs, no digital signals			• For Super Audio CDs, use the analog audio	7
	are output.			output signals.
	• Turn the pure direct mode on.			• Turn the pure direct mode off.	9
A specific section of the disc	• The disc is dirty or scratched.			• Wipe the dirt off the disc or replace the	3
cannot be played properly.				disc.
Programmed playback is not	• The tracks have not been programmed			• Program properly.	9, 10
possible.	properly.
A CD-R or CD-RW disc cannot be	• The disc has not been finalized.			• Finalize the disc then play it.	2
played.	• The recording conditions are bad or the			• Use a properly recorded disc.	2
	quality of the disc itself is poor.
Files recorded in MP3 or WMA	• You have selected a copyright-protected			• Press the 8 or 9 button to select a	11
format cannot be played.	WMA file or a file that cannot be played			different file.
	normally.
Set does not operate properly	• The batteries are spent.			• Replace the batteries with new ones.	4
when remote control unit is	• The remote control unit is too far from the			• Move the remote control unit closer to the	4
operated.	set.			set.

13