Connections Fader Start
ENGLISH
Specifications
Q5 CROSSFADER CONTOUR control
Allows adjusting the “shape” of the Crossfader
response from a gentle curve for smooth, long
running fades, to the steep pitch required for top
performance cut and scratch effects.
Q6 CH FADER CONTOUR control
Adjusts the volume curve response of the
channel fader.
Q7 CH FADER START switch
This function will start the performance of CD
player with Ch. Fader automatically is on/off.
FADER START
If the separately sold DN-S1200, DN-S3500,
DN-HS5500 and etc. players are connected to
LINE2, 4, 6 or 8, they can be started using the
source input fader (Ch. Fader) or Crossfader, as
long as the 3.5 mm stereo mini cords have been
connected.
Q8 MASTER BALANCE control
Adjusts the L/R balance of the MASTER output.
Q9 EFFECTS ON/OFF button
• Routes the assigned signal through the external
processor attached to the SEND/RETURN
connectors on the rear.
• When the EFFECT is ON, the button is lit.
• The effect button is flashing when there is no
connection of the effects.
W0 EFFECTS WET/DRY control
Use this to adjust the ratio of original and
effected sound.
W1 PRE/POST switch (EFFECTS)
Use this to select pre-fader or post-fader.
W2 EFFECTS ASSIGN switch
Use this to select the source of the external
processor.
W3 CUE buttons
Pressing in any or all of CUE buttons routes the
respective source to the headphone and meter
cue sections. Pressing multiple buttons makes
it possible to derive mixed sound from the
selected sources.
W4 BOOTH LEVEL control
Adjusts the level of the BOOTH outputs.
W5 BOOTH ASSIGN switch
Selects the source of the BOOTH output.
W6 POWER switch
Press the switch to turn the power on.
W7 Peak dB CUE/PROGRAM meter
• Displays the output level following Master Level
adjustment, the peak level is held for 1 second.
Display range: –24 dB to +12 dB.
• Can switch between two display modes. See
below u, i.
W8 MASTER LEVEL control
Adjusts the level of the MASTER outputs.
W9 POWER indicator
When the red indicator is lit, the DN-X1100 is
ready to go.
E0 Source EQ controls
Use VRs with center detent for equaliser.
HI
Adjusts the high-tone sound –33 dB to +10 dB.
At the center position, sound is flat.
MID
Adjusts the mid-tone sound –35 dB to +10 dB.
At the center position, sound is flat.
LOW
Adjusts the low-tone sound –35 dB to +6 dB. At
the center position, sound is flat.
E1 LEVEL controls
Adjusts the level of the selected input – ∞ to
+15 dB.
E2 SOURCE INPUT SELECT switches
(Input selectors)
• Select any source from eight inputs (PHONO1/
LINE1, LINE2, PHONO2/LINE3, LINE4, PHONO3/
LINE5, LINE6, LINE7, LINE8) for each channel
independently.
• You also can assign the same input to several
channels for creative mixing.
E3 CH LEVEL meter
Display range: –24 dB to +12 dB.
Displays the input level after adjusted with
LEVEL E1 and Source EQ E0 controls.
Getting Started