Connections

¢AM loop antenna assembly

Connection of AM antennas

ENGLISH

Connections

Connecting the XM terminal

12

Remove the vinyl tie and take out the connection line.

4

a. With the antenna on top any stable surface.

Mount

b. With the antenna attached to a wall.

Connect to the AM antenna terminals.

3

Bend in the reverse direction.

1. Push the lever.

2. Insert the conductor.

3. Return the lever.

•DRA-37 is the XM Ready® receiver. You can receive XM® Satellite Radio by connecting to the XM Mini- Tuner and Home Dock (includes home antenna, sold separately) and subscribing to the XM service.

•Plug the XM Mini-Tuner Home Dock into XM terminal on the rear panel.

•Position the Home Dock antenna near a south-facing window to receive the best signal.

For details, see “XM Satellite Radio” ( page 13).

When making connections, also refer to the operating instructions of the XM Mini-Tuner and Home Dock.

XM Mini-Tuner andHome Dock

AUX OUT

MX

Installation hole Mount on wall, etc.

NOTE:

•Do not connect two FM antennas simultaneously.

•Even if an external AM antenna is used, do not disconnect the AM loop antenna.

•Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

NOTE:

•Keep the power supply cord unplugged until the XM Mini-Tuner and Home Dock connection have been completed.

•The XM name and related logo are registered trademarks of XM Satellite Radio Inc. All rights reserved.

•XM Ready is a registered trademark of XM Satellite Radio Inc. All rights reserved.

8

ENGLISH