Specifications Holes Ventilation the About Net Speaker the Removing Connections Started Getting

ENGLISH

Bi-wiring Connections

The speaker (SC-CX101) input terminals and circuitry allows bi-wiring connections with the treble (upper tier) and bass (lower tier) isolated and independent. This enables playback of high quality sound without the audio signal interference resulting from the difference in level between the treble and bass.

b Use two speaker cables per SC-CX101 unit.
b Remove the short-circuit cords from the “+” and “–” sides.
n Connecting to an amplifier with two sets of speaker outputs (A+B)

Set the speaker output selector switch to “A+B”.

 

Connect to amplifier’s

Tweeter

A speaker “+” side.

terminals

 

 

Connect to amplifier’s

 

A speaker “–” side.

 

Connect to amplifier’s

 

B speaker “+” side.

Woofer

Connect to amplifier’s

terminals

 

B speaker “–” side.

n Connecting to an amplifier with only one set of speaker outputs

Also use this procedure to connect to amplifiers on which it is not possible to output A and B simultaneously even if the amplifier has two sets of outputs, or amplifiers on which the two sets of outputs are connected in series.

To speaker “+” terminal

To speaker “–” terminal

b Twist the tip firmly

•The SC-CX101’s impedance does not change even when using with bi-wiring connections.

•For even more advanced enjoyment, if you have two amplifiers you can set up a bi-amp drive system. In this case, set the outputs of the two amplifiers to the same level.

CAUTION

If the amplifiers have different output levels, only the treble or the bass will be emphasized and it will be impossible to achieve the optimum balance between the two.

Removing the Speaker Net

The net on the front of the speakers can be removed.

To remove, grasp both sides of the net and pull forward.

b To mount, line up the projecting pieces in the four corners of the speaker net with the holes in the four corners of the cabinet and press in.

About the Ventilation Holes

Two ventilation holes are provided in the tweeter dome and edge to prevent warping of the diaphragm due to thermal expansion of the air in the tweeter dome.

b The holes are normal and do not indicate damage.

Ventilation holes

Tweeter dome