Tune Settings

1.Disconnect the power to the doorbell button and chime.

2.Open the cases and locate the jumpers on both the doorbell button and chime (See illustration).

3.The doorbell button and chime both have eight different jumper locations. The jumper positions 1 through 7 are used for setting the code.

4.To change the code, add and/or remove jumpers as needed. There are 128 different combinations. It is recommended to only change one jumper at a time and then check to see if system is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly the same for both the doorbell button and chime for this system to function.

Your Heath®/Zenith wireless doorbell has 2 different selectable tunes: Ding (one note) or Ding-Dong(two note). The factory setting is for the Ding-Dong; however, this can be changed by following the instructions below.

•Ding (one note tune)

Doorbell button: Add a jumper to location 8.

•Ding-Dong(two note tune)

Doorbell button: Remove jumper from location 8.

Remove screw to open access door

Back of

Doorbell Button Battery Replacement

Install an alkaline type A23 12 Volt bat- tery. The positive terminal should be po- sitioned as shown.

Chime 12345678