OPERATING | 4. Wait five (5) minutes to clear out any gas. Then smell for gas, including | ||
HEATER | near the floor. If you smell gas, STOP! Follow “B” in the safety information | ||
at the top of page 17. If you don’t smell gas, go to the next step. | |||
Thermostat Models | 5. Turn control knob counterclockwise | ||
Continued | |||
in control knob for five (5) seconds (see Figure 16). | |||
| Note: You may be running this heater for the first time after hooking up | ||
| to gas supply. If so, the control knob may need to be pressed in for 30 | ||
| seconds. This will allow air to bleed from the gas system. | ||
| • If control knob does not pop up when released, contact a qualified | ||
| service person or gas supplier for repairs. |
| |
| 6. With control knob pressed in, push down and release ignitor button. This | ||
| will light pilot. The pilot is attached to the front of burner. The pilot can be | ||
| seen through the glass panel. If needed, keep pressing ignitor button until | ||
| pilot lights. |
| |
| Note: If pilot does not stay lit, refer to Troubleshooting, pages 24 through | ||
| 27. Also contact a qualified service person or gas supplier for repairs. | ||
| Until repairs are made, light pilot with match. To light pilot with match, | ||
| see Manual Lighting Procedure, page 19. |
| |
| 7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 | ||
| seconds, release control knob. |
| |
| Ignitor Electrode | ||
| Thermocouple | Pilot Burner | |
|
| ||
Figure 17 - Pilot
Note: If pilot goes out, repeat steps 3 through 7. This heater has a safety interlock system. Wait one (1) minute before lighting pilot again.
8. Turn control knob counterclockwise 
to desired heating level. The main burner should light. Set control knob to any heat level between HI and LO.
CAUTION
WARNING ICON | G 001 |
Do not try to adjust heating levels by using the manual shutoff valve.
18
099569
