PRODUCT IDENTIFICATION
UNPACKING
ASSEMBLY
4
Hot Air Outlet
| Upper Shell |
Lower Shell | Motor and |
| Pump |
| Assembly |
Fuel Cap
Thermostat
Power Cord
Burner Control | Fuel Tank | |
Reset Button | ||
|
Figure 1 - B350CEA Btu/Hr Model
1.Remove all protective packing applied to heater for shipment.
2.Remove heater from shipping container.
3.Check heater for any shipping damage. If heater is damaged, promptly inform dealer where you bought heater.
This model is furnished with wheels and front and rear handles. Wheels, handles, and mounting hardware are found in the shipping carton.
TOOLS NEEDED
•Pliers
•Two - 7/16" Open or Adjustable Wrenches
1.Slide axle through wheel support frame. Install wheel spacer and then one flat washer on each end of axle.
2.Install wheels on axle.
IMPORTANT: When installing wheels, point exetended hub of wheels toward wheel support frame (see Figure 2, page 5).
3.Slide one flat washer on each axle end in front of wheel.
4.Install cotter pins through holes at each end of axle. Bend cotter pins with pliers to secure.
5.Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Line up holes on fuel tank flange with holes on wheel support frame.
6.Place front and rear handles on top of fuel tank flange. Insert screws through handles, fuel tank flange, and wheel support frame. Attach nut finger tight after inserting each screw.
7.After inserting all screws, tighten nuts firmly.
103807
