INSTALLATION
Continued
1.Place middle log (#1) onto log alignment screw located near the center of base, and in place over log support bracket as shown in Figures 17 and 18.
2.Place front log (#2) onto base. Position log onto two alignment screws to the front of base (see Figure 18).
3.Place left side log (#3) onto two log alignment screws on left side of base (see Figure 18).
4.Place right side log (#4) onto two log alignment screws on right side of base (see Figure 18).
5.Place rear log (#5) onto two alignment screws to the rear of base (see Figures 17 and 19).
6.Place crossover log (#6) onto log alignment pin on middle log (#1) and rear log (#5) (see Figure 19).
Left Log |
| Rear Log | |
|
| ||
|
| Log Support | |
|
| Bracket | |
Front |
|
| |
Log |
|
| |
Middle |
| Right | |
Log |
| ||
Front Log | Log | ||
| |||
|
| ||
Figure 17 - Log Alignment Screws | |||
|
| Middle | |
|
| Log #1 | |
Left Log #3
Front
Log #2
Right
Log #4
Crossover
Log #6
Rear
Log #5 
Figure 19 - Installing Rear Log #5 and
Crossover Log #6
ATTACHING GRATE TO BASE ASSEMBLY
Locate the two slots in the front of the base as- sembly. Carefully slide the decorative grate into these slots (see Figure 20).
Grate 
Slots in Base
Figure 20 - Attaching Grate to Base Assembly
ADDING LAVA ROCK
Place lava rock around base of heater if desired. Be sure not to cover the control knobs or air inlet openings on the front of heater.
Figure 18 - Installing Middle Log #1, Front
Log #2, Left Log #3 and Right Log #4
www.desatech.com | 15 |
