OWNER’S MANUAL
PRODUCT
IDENTIFICATION
Back Log
Crossover Log
Front Log
Optional | Burner |
Remote | |
Control |
|
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by realistic dancing, yellow flames. This heater is designed for
Piezo Ignitor
Optional Selector Switch
Flame Adjustment Knob
Middle Log
Base Grate
Control Knob
models only).
SAFETY PILOT
This heater has a pilot with an Oxygen Depletion Sensor Shutoff System (ODS). The ODS/pilot is a required feature for vent- free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.
Figure 1 - Yellow Flame Vent-Free Gas Log Heater Shown (Logs May Vary by Model)
PIEZO IGNITION SYSTEM
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANS Z223, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note: Where listed vented decorative logs are required, thermostat operation is not permitted.
UNPACKING
CAUTION: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.
1.Remove logs and heater base assem- bly from carton. Note: Do not pick up heater base assembly by burners. This could damage heater. Always handle base assembly by grate.
2.Remove all protective packaging ap- plied to logs and heater for shipment.
3.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought heater.
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
REMOTE CONTROL ACCESSORIES
There are two optional remote controls that can be purchased separately for this log heater:
•
•
See Accessories, page 27.
The
105677 | 3 |
