OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING FIREPLACE SCREEN
1.Insert each rod through nine rings lo- cated at top of screen.
2.Insert first rod into rear hole in left side of firebox. Fasten rod to rear hole near center of firebox using black shoulder screw.
3.Insert other rod into front hole on right side of firebox and fasten using remain- ing shoulder screw.
Rear Hole
Screw
Front Hole
Rod
Ring
Screen
Figure 11 - Installing Fireplace Screen
FIREBOX INSTALLATION USING OPTIONAL ACCESSORY MANTELS
This firebox may be installed using the cabi- net mantel and hearth base accessories against a wall in your home. Follow the instructions below to install the firebox in this manner.
Note: The instructions below show installa- tion using GMC11F/GMC12U/GMC13F series cabinet mantels and the GC3333F/ GC3334U/GC3335F series hearth base ac- cessories. The hearth base accessory shown is optional for this installation. You can install firebox and cabinet mantel directly on the floor.
1.Assemble cabinet mantel, hearth base, and perimeter trim (Included with man- tel). Assembly instructions are included with each accessory.
2.If using an optional GA3750 blower, install a properly grounded, 120 volt
3.Install gas piping to firebox location. This installation includes an approved flex- ible gas line (if allowed by local codes) and a manual shutoff valve. The flexible gas line must be the last item installed on the gas piping. See Connecting to Gas Supply in your log set owner’s manual.
WARNING: A qualified ser- vice person must connect fire- box to gas supply. Follow all lo- cal codes.
4.Place hearth base accessory against wall at installation location. Cut an access hole in hearth top to run flexible gas line to firebox (see Figure 12). Make sure to locate access hole so cabinet mantel will cover it when installed. Note: You can secure base to floor using wood screws. Countersink screw heads and putty over.
5.Route flexible gas line through access hole in hearth base.
6.Center cabinet mantel on hearth base (see Figure 13). Make sure mantel is flush against wall.
7.Break off nailing flanges (see Figure 14) with hammer or pliers.
8.Place cardboard or other protective material on top of hearth base. Care- fully set firebox on protective material, with back of firebox inside mantel opening.
Electrical
Flexible Gas Line Outlet
Hearth Base | Gas | |
Line | ||
| ||
| Access | |
| Hole |
Figure 12 - Placing Hearth Base Accessory Against Wall
9.Attach flexible gas line to log set. See Connecting to Gas Supply in your log set owner’s manual.
10.If installing GA3750 blower, route blower electrical cord through bushing in right side firebox support and bush- ing in side access opening of firebox. Plug electrical cord into electrical out- let. See Installing Blower Accessory, page 8.
11.Carefully insert firebox into cabinet man- tel. Be careful not to scratch or damage cabinet mantel or hearth base. Remove protective material from top of hearth base and from front of firebox (if any).
12.Install the trim after final finishing and/ or painting of wall. See instructions in- cluded with mantel accessory for at- taching brass trim.
13.Check all gas connections for leaks. See Checking Gas Connections in log set owner's manual.
Cabinet
Mantel
Figure 13 - Installing Cabinet Mantel
Nailing
Flanges
Figure 14 - Location of Nailing Flanges
Continued
103573 | 9 |
