Continued LIGHTING INSTRUCTIONS, Manual Lighting Procedure

C-clockwise

CGP10A AND CGP6

PROPANE/LP GAS HEATER

OPERATING

HEATER

Continued

LIGHTING

INSTRUCTIONS

1.STOP! Read the safety information, page 9.

2.Make sure manual shutoff valve is fully open.

3. Turn control knob clockwise Clockwise

Note: If pilot does not stay lit, refer to Troubleshooting, pages 12 through

14.Also contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure.

7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

Note: If pilot goes out, repeat steps

3through 7.

MANUAL LIGHTING

PROCEDURE

1.	Remove front panel (see Figure 10,
	page 12).
2.	Follow steps 1 through 5 under Light-
	ing Instructions.
3.	With control knob pressed in, strike
	match. Hold match to pilot until pi-
	lot lights.
4.	Keep control knob pressed in for 30
	seconds after pilot is lit. After 30 sec-
	onds, release control knob.

to the OFF position.

Ignitor Button		Control Knob
	PILOT	OFF
	PILOT

HIGH

IGNITOR

LOW

Thermocouple

Ignitor Electrode

Pilot

Burner

5. Replace front panel.

Figure 16 - Control Knob In The OFF Position

4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation at the top of column 3, page 9. If you don’t smell gas, go to the next step.

5.Press in control knob and turn coun-

terclockwise to the PILOT position. Keep control knob pressed in for five (5) seconds (see Figure 16).

Note: You may be running this heater for the first time after hook- ing up to gas supply. If so, the con- trol knob may need to be pressed in for 30 seconds. This will allow air to bleed from the gas system.

•If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

6.With control knob pressed in, push down and release ignitor button. This will light pilot. The pilot is attached to the front of burner. The pilot can be seen through the glass panel. If needed, keep pressing ignitor button until pilot lights.

Figure 17 - Pilot

8.Turn control knob counterclockwise

C-clockwiseto the HIGH position. The main burner should light. Set control knob to any heat level between HIGH and LOW. To turn control knob from HIGH to a lower setting, press in the control knob and turn counterclock-