Servicing
Continued
Backlight LED Strip
1.Follow steps 1 through 4 under Service Preparation, page 10.
2.Disconnect wires from backlight LED strip.
3.Squeeze top of standoffs to remove back- light LED strip and discard.
4.Place new backlight LED strip onto stand- offs and push gently.
5.Connect wires to backlight LED strip (see Wiring Diagram, page 14).
6.Follow steps 11 through 13 under Service Preparation, page 10.
Backlight
LED Strip
Standoffs
Figure 21 - Replacing Backlight LED
Strip
Remote Control Sensor
1.Follow steps 1 through 6 under Service Preparation, page 10.
2.Disconnect wire from remote control sen- sor board.
3.Squeeze top of standoffs to remove board.
4.Gently push new board onto standoffs.
5.Connect wires to remote sensor board.
6.Follow steps 8 through 13 under Service Preparation, page 10.
Settings Control Board
1.Follow steps 1 through 6 under Service Preparation, page 10.
2.Disconnect wire from settings control board.
3.Remove screws from bracket to remove settings control board (see Figure 23).
4.Place new settings control board into posi- tion making sure each control is aligned with slot in panel. Install using screws from step 3. DO NOT overtighten. This will damage control board.
5.Reconnect wire to settings control board (see Wiring Diagram, page 14).
6.Follow steps 8 through 13 under Service Preparation, page 10.
Settings
Control
Board 
Screw
Figure 23 - Replacing Settings Control
Board
Figure 22 - Replacing Remote Control
Sensor
www.desatech.com | 13 |