Servicing
Continued
Transformer
1.Follow steps 1 through 6 under Service Preparation, page 10.
2.Disconnect transformer wires from control board.
3.Remove 2 screws from firebox surround to remove transformer (see Figure 18).
4.Remove and discard transformer.
5.Place new transformer against inside of firebox surround and replace screws removed in step 3.
6.Reconnect transformer wires to control board (see Wiring Diagram, page 14).
Blower
Heater
Figure 19 - Removing Heater from
Blower
6.Follow steps 8 through 13 under Service Preparation, page 10.
Screws
Transformer
Nuts
Figure 18 - Removing Transformer
Heater
1.Follow steps 1 through 6 under Service Preparation, page 10.
2.Disconnect wires from heater.
3.Remove 4 screws from side of heater, see (Figure 19).
4.Install new heater.
5.Connect wires to new heater (see Wiring Diagram, page 14)
6.Follow steps 8 through 13 under Service Preparation, page 10.
Blower Assembly
1.Follow steps 1 through 6 under Service Preparation, page 10.
2.Disconnect wires from heater/blower as- sembly.
3.Remove 4 screws holding blower/heater and brackets to fireplace top (see Figure
20).
4.Remove 4 screws securing heater to blower (see Figure 19).
5.Install old heater onto new blower with screws removed in step 4.
6.Install new blower/heater assembly to top panel with screws removed in step 3.
7.Reconnect wires to blower/heater assem- bly (see Wiring Diagram, page 14).
8.Follow steps 8 through 13 under Service Preparation, page 10.
Brackets
Figure 20 - Removing Blower/Blower
Assembly
12 | www.desatech.com |