Desa FMH26TN Product Features, Local Codes, Unpacking, Product Identification, Continued

OWNER’S MANUAL

SAFETY

INFORMATION

Continued

14.Turn off and unplug fireplace and let cool before servicing. Only a qualified service person should service and re- pair fireplace.

15.Operating fireplace above elevations of 4,500 feet could cause pilot outage.

16.Do not operate fireplace if any log is broken. Do not operate fireplace if a log is chipped (dime-sized or larger).

17.Provide adequate clearances around air openings.

PRODUCT

FEATURES

SAFETY PILOT

This fireplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff sys- tem. The ODS/pilot is a required feature for vent-free room fireplaces. The ODS/pilot shuts off the fireplace if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This fireplace has a piezo ignitor. This sys- tem requires no matches, batteries, or other sources to light fireplace.

LOCAL CODES

Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

UNPACKING

THERMOSTATIC HEAT

CONTROL

This fireplace has a thermostat sensing bulb and a control valve. The thermostat will automatically modulate the heat output to maintain a consistent room temperature. This results in greater fireplace comfort. This can also result in lower gas bill.

PRODUCT IDENTIFICATION

Fireplace

Cabinet

Screen

Logs

Control Knob

Ignitor Button

Figure 1 - Vent-Free Natural Gas Fireplace System

1.Remove log box and fireplace from carton. The hood is not attached. IMPORTANT: The fireplace hood is inside the cardboard protective end wrap on the left side of fireplace (as viewed from front). A decal is on the outside of the cardboard end wrap stat- ing hood is enclosed (see Figure 2).

2.Remove hood from cardboard protec- tive end wrap as shown in Figure 2.

3.Remove all protective packaging ap- plied to fireplace for shipment.

4.Make sure your fireplace includes one hardware packet.

5.Check fireplace for any shipping damage. If fireplace is damaged, promptly inform dealer where you bought fireplace.

Hood	IMPORTANT:
Enclosed	THIS PACKAGE CONTAINS A
	FIREPLACE HOOD. UNWRAP
Decal	CARTON AND REMOVE HOOD
	BEFORE DISCARDING
	PROTECTIVE PACKAGING.
	Cardboard
	Protective
	Fireplace
	End Wrap
	2
	1
	Hood

Figure 2 - Removing Fireplace Hood

107105 3