107304
For more information, visit www.desatech.com
For more information, visit www.desatech.com
8

NOTICE: If installing blower in an existing stove

burner system with gas connections, shut off gas

supply and disconnect heater from gas supply. Con-

tact a qualified service person to do this.

INSTALLING OPTIONAL BLOWERACCESSORYINSTALLING THE BLOWER

1. Remove 4 hex screws securing rear cover to back of stove body

(see Figure 16).

2. Separate bottom cover from rear cover by loosening the 8

mounting screws (see Figure 16).

3. Align the holes in the top mounting tabs of blower with the

holes in wall of rear cover. Using the 4 screws provided, mount

blower and tighten screws securely (see Figure 17).

Figure 17 - Blower Assembly, Speed Control, and Thermal

Switch Locations

Figure 16 - Removing Rear Cover and Bottom Cover from Stove

Body

Speed
Control
Blower
Control
Knob Locknut
Blower
Assembly
Thermal
Switch and
Bracket
Control
Shaft
TOP VIEW
Stove Body
Rear Cover
Bottom Cover
Hex
Screws
Mounting
Screws
Mounting
Screws
Hex Screws Mounting
Screws
Mounting Holes
Screws
Mounting
Holes
INSTALLING DIRECT-VENT BURNERSYSTEM INTO STOVE BODY

1. Carefully lift burner system and place into stove body from

the rear of stove.

2. Place the left and right grate tops into the top of stove body. Dis-

card center grate top of stove and replace with center grate top

provided with burner system.

Figure 15 - Installing Burner System Into Cast Iron Stove Body

L
O
H
I
P
I
L
O
T
OFF
ON
Cast Iron
Stove Body
Burner
System
Right Top
Grate
Center Top Grate
(Included with
Burner System)
Left Top
Grate
CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
Continued
CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
Installing Direct-Vent Burner System Into Stove Body
Installing Optional Blower Accessory