Inspecting Burner

Check pilot flame pattern and burner flame patterns often.

PILOT FLAME PATTERN

Figure 38 shows a correct pilot flame pattern. Figure 39 shows an incorrect pilot flame pat- tern. The incorrect pilot flame is not properly heating the thermocouple. When the thermocouple cools, the heater will shut down.

If pilot flame pattern is incorrect, as shown in Figure 39

turn heater off (see To Turn Off Gas to Ap- pliance, page 20)

see Troubleshooting, page 25

Note: The pilot flame on a natural gas units will have a slight curve, but flame should be blue and have no yellow or orange color.

Thermocouple

Pilot Burner

Figure 38 - Correct Pilot Flame Pattern

(Natural Gas Pilot Shown)

Pilot Burner

Thermocouple

 

Figure 39 - Incorrect Pilot Flame Pattern

(Natural Gas Pilot Shown)

BURNER PRIMARY AIR HOLES

Air is drawn into the burner through the holes in the fitting at the burner entrance. These holes may become blocked with dust or lint. Periodically inspect these holes for any blockage and clean if needed. Blocked air holes will create soot.

main burner

Periodically inspect all burner flame holes with the fireplace running. All slotted burner flame holes should be open with yellow flame pres- ent. All round burner flame holes should be open with a small blue flame present. Some burner flame holes may become blocked by debris or rust, with no flame present. If so, turn off fireplace and let cool. Remove blockage. Blocked burner flame holes will create soot.

BURNER FLAME PATTERN

WARNING: If yellow tipping occurs,yourfireplacecouldproduce increased levels of carbon monoxide.

NOTICE: Do not mistake orange flames with yellow tipping. Dirt or other fine particles enter the fireplace and burn causing brief patches of orange flame.

Figure 40 shows a correct burner flame pat- tern. Figure 41 shows an incorrect burner flame pattern. The incorrect burner flame pattern shows the flame higher consistently higher than 1" above the logs.

If burner flame pattern is incorrect, as shown in Figure 41

turn heater off (see To Turn Off Gas To Appliance, page 20)

see Troubleshooting, page 25

Figure 40 - Correct Burner Flame Pattern

Yellow Tipping

Figure 41 - Incorrect Burner Flame

Pattern

113109-01G

www.desatech.com

23