Desa HCA-18-RFP, HCA-18-RFN, HCA-24-RFN, HCA-24-RFP Operating Appliance, Floor Media Kits Installed

INSTALLATION

Continued

3.Place fiber log pieces randomly on lava rock and ember material around unit (see Figure 10).

4.Use remaining lava rock to blend the floor media together. Your finished effect should resemble Figure 11.

WARNING: Failure to posi- tion the floor media as shown in Figures 8 through 11 or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.

Figure 11 - Floor Media Kits Installed

OPERATING APPLIANCE

The RF Millivolt valve control used on these appli- ances allows you to turn the gas log set on or off; use a timer to automatically operate the log set; increase or decrease flame height, fan speed or timing. An easy-to-read display gives you information about room temperature, set temperature, flame height level, fan speed level and a countdown timer, as well as a low battery indication. Figure 12 shows the location of the controls and indicators for the transmitter (remote) and the receiver (valve).

Note: Fan operations are not applicable to these Hardwood Series.

TRANSMITTER/REMOTE

Figure 8 - Placing Lava Rock

Mode

Button

Timer

Button

Display

Up Arrow Down Arrow

RECEIVER/VALVE

Figure 9 - Placing Ember Material

Piezo

Manual Switch

PilotStat Knob

LED

Figure 12 - RF Millivolt Valve Controls

with Transmitter/Remote

Figure 10 - Placing Fiber Log Pieces

115481-01A www.desatech.com 9