Desa HDCFTP installation manual Product Features, Unpacking, Assembly

PRODUCT FEATURES

SAFETY PILOT

This fireplace has a pilot with an Oxygen Deple- tion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent-free room fireplaces. The ODS/pilot shuts off the fireplace if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This fireplace has a piezo ignitor. This system requires no matches, batteries, or other sources to light fireplace.

THERMOSTATIC HEAT CONTROL

This fireplace has a thermostat sensing bulb and a control valve. The thermostat will automatically modulate the heat output to maintain a consistent room temperature. This results in greater fireplace comfort. This can also result in lower gas bills.

UNPACKING

1.Remove log box and fireplace from carton. IMPORTANT: The fireplace hood is inside the cardboard protective end wrap on the left side of fireplace (as viewed from front). A decal is on the outside of the cardboard end wrap stating hood is enclosed (see Figure 2).

2.Remove hood from cardboard protective end wrap as shown in Figure 2.

3.Remove all protective packaging applied to fireplace for shipment.

4.Make sure your fireplace includes one hard- ware packet.

5.Check fireplace for any shipping damage. If fireplace is damaged, promptly inform dealer where you bought fireplace.

Hood		IMPORTANT:
Enclosed		THIS PACKAGE CONTAINS A
		FIREPLACE HOOD. UNWRAP
Decal		CARTON AND REMOVE HOOD
		BEFORE DISCARDING
		PROTECTIVE PACKAGING.
		Cardboard
		Protective
		Fireplace
		End Wrap
		2
	1	Hood

Figure 2 - Removing Fireplace Hood

ASSEMBLY

WARNING: Always have branch support and screen in place before operating fireplace. This prevents excessive temper- atures on fireplace surfaces.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in prop- erty damage or personal injury.

ASSEMBLING FIREPLACE
Tools Required:
•	Phillips screwdriver	•	slotted screwdriver
•	5/16" hex wrench	•	scissors
Installing Log

1.Lift screen up and pull out to remove.

2.Cut two plastic straps to remove the log from the firebox cavity.

3.An optional blower is available for models CGCFTP and CGCFTN. See Accessories, page 30. Install optional blower now. Follow instal- lation instructions provided with blower.

4.Remove log packaging material and discard packaging. Gently place log set on burner support (see Figure 3). The log should fit flat against top of burner support and log locator tabs fit into the slots under the log. Do not allow log to contact flame. If flame contacts log, soot will be created.

5.Reattach screen by placing the notches in the screen frame over the shoulder screws and pushing down.

Log	Shoulder	Burner Support
	Screw	with Log
		Locator Tabs
Screen
		Branch
		Support
Figure 3 - Assembling Fireplace

111044-01E www.desatech.com 5