INSTALLATION
Continued
4.If using GA3750A blower accessory, see
5.Attach flexible gas line to log set. See Connecting to Gas Supply in log set owner’s manual.
6.Carefully insert firebox into rough opening.
7.Attach firebox to wall studs using nails or wood screws through holes in nailing flange (see Figure 15).
8.Check all gas connections for leaks. See Checking Gas Connections in log set owner’s manual.
9.If using optional perimeter trim, install the
trim after final finishing and/or painting of wall. See instructions included with perimeter trim accessory for attaching perimeter trim or see.
IMPORTANT: When finishing your firebox, combustible materials such as wall board, gypsum board, sheet rock, drywall, plywood, etc. may be butted up next to the sides and top of the firebox. Combustible materials should never overlap the firebox front facing.
WARNING: Do not allow any combustiblematerialstooverlap the firebox front facing.
Nails or
Wood
Screws
Nailing
Flanges
Figure 15 - Attaching Firebox to Wall Studs
| Actual | Framing |
Height | 32 1/2" | 33" |
Front Width | 34 5/16" | 34 3/4" |
Depth | 16 11/16" | 17 3/4" |
IMPORTANT: Noncombustible materials such as brick, tile, etc. may overlap the front facing, but should never cover any necessary openings like louvered slots.
WARNING: Do not allow noncombustible materials to cover any necessary openings like louvered slots.
WARNING: Use only non- combustible mortar or adhesives whenoverlappingthefront facing with noncombustible facing material.
ASSEMBLING AND INSTALLING TRIM
1.Remove packaging from 3 pieces of trim.
2.Locate 2 adjusting plates with set screws and 2 shims in hardware packet.
3.Align shim under adjusting plate as shown in Figure 16.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 16).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 16).
6.While firmly holding edges of trim together, tighten both set screws on adjusting plate with slotted screwdriver.
7.Repeat steps 2 through 6 or other corner.
8.Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the assembled trim onto fireplace cabinet. Align hanging notches on trim with hang- ing screws on side of fireplace (see Figure 17, page 12). Push trim firmly into place, sliding hanging notches over hanging screws.
Set | Slot |
| |
Screws | Top Trim |
| |
| Mitered Edge |
Adjusting | Side Trim |
Plate |
|
Shim | Slot |
Figure 16 - Assembling Trim
www.desatech.com | 11 |