INSTALLation
Continued
5.Connect wires from the electrical box to duplex outlet. Match wire colors to those indicated on duplex outlet. Be sure to connect ground wire.
6.Replace duplex outlet with screw.
7.Plug blower power cord into duplex outlet.
8.Replace bottom of firebox.
| Cables From | |
Blower | Electrical Source | |
Support Bracket | ||
|
Duplex
Outlet
Screw
Blower Power Cord
Figure 9 - Routing Blower Accessory Power Cord for
Operating Blower
Light your gas appliance with the blower off. After about 15 minutes, turn the blower on to deliver heated air at the top louvers. The blower features a variable control which allows you to select the speed you desire.
Note: Periodically check the louvers of the firebox and remove any dust, dirt or other obstructions.
Installing LOG HEATER IN
FIREBOX
CAUTION: Do not pick up log base assembly by burners. This could damage burners. Only handle base by grates.
CAUTION:Donotremovethe dataplatesattachedtotheheater base assembly. The data plates contain important warranty and safety information.
1.Remove 4 screws holding firebox bottom in place.
2.Lift and remove firebox bottom (see Figure 10).
3.If installing GA3750A blower accessory, see Installing Blower Accessory, page 8.
4.Route flexible gas line from equipment shutoff valve into firebox through side.
NOTICE: Most building codes do not permit concealed gas connections. A flexible gas line is recommended to allow accessibility fromthefirebox. Theflexible gas supply line connection to the equipment shutoff valve should be accessible.
5.Attach gas log heater base to firebox bot- tom with four screws included with base
(see Installing Heater Base Assembly in log set owner’s manual).
6.Replace firebox bottom and secure with screws.
Figure 10 - Removing Firebox Bottom
INSTALLING FIREPLACE HOOD
NOTICE: The firebox canopy (hood) must not be modified or replaced with a canopy (hood) that may be provided with the unvented decorative room heater.
1.Attach three
2.Insert hood into
3.Hold hood in place. Insert two black Phil- lips screws through bottom of hood and tighten. See Figure 11, page 10.
www.desatech.com | 9 |