INSTALLATION

Continued

Hood

Hood

 

 

Mounting

 

Slot

Shoulder

Screw

Screw

Figure 11 - Installing Fireplace Hood

INSTALLING FIREPLACE SCREEN

1.Insert each rod through nine rings located at top of screen (see Figure 12).

2.Insert first rod into rear hole in left side of firebox. Fasten rod to rear hole near center of firebox using black shoulder screw.

3.Insert other rod into front hole on right side of firebox and fasten using remaining shoulder screw.

Screw

Front and

Rear Hole

Rod

Ring

Screen

Figure 12 - Installing Fireplace Screen

Firebox Installation USING

OPTIONAL ACCESSORY MANTELS

This firebox may be installed using the corner or cabinet mantel with hearth base against a wall in your home. A perimeter trim kit is included with the mantel accessories (see Accessories, page 13).

Built-In Firebox Installation

Built-in installation of this firebox involves installing firebox into a framed-in enclosure. This makes the front of firebox flush with wall. Optional perimeter trim is available (see Accessories , page 13) This perimeter trim will extend past sides of firebox approximately 1/2". This will cover rough edges of the wall opening. If installing a mantel above the fire- box, you must follow the clearances shown in Figure 7, page 8. Follow the instructions below to install the firebox in this manner.

1.Frame in rough opening. Use dimensions shown in Figure 13 for the rough opening. If installing in a corner, use dimensions shown in Figure 14 for the rough opening. The height is 33", which is the same as the wall opening in Figure 13.

2.Install gas piping to firebox location. This installation includes an approved flexible gas line (if allowed by local codes) after the equipment shutoff valve. The flexible gas line must be the last item installed on the gas piping. See Connecting to Gas

Supply in log set owner’s manual.

3.Carefully set firebox in front of rough open- ing with back of firebox inside wall opening. IMPORTANT: If installing perimeter trim, see instructions included with perimeter trim accessory. You must install shoulder screws now.

17 3/4"

33"

34 3/4"

Figure 13 - Rough Opening for Installing

in Wall

393/8"

27 7/8"

34 3/4" 55 5/8"

Figure 14 - Rough Opening for Installing

in Corner

10

www.desatech.com

119505-01E