OPERATION
Continued
4. Start the engine.
A. Recoil Starter
Turn engine switch to the ON position (see Figures 16 and 17). Remove slack from starter rope by lightly pulling starter grip. Next, pull starter rope briskly.
IMPORTANT: Do not let starter grip snap back against engine. Return it gently. This will prevent damage to starter.
Note: If engine does not start, check the oil in the crankcase. Add oil as necessary. Be sure engine is on a level surface. See oil alert system, page 9.
ENGINE SW
ON
OFF
Figure 16 - Engine Switch In ON Position (All Models Except MGH7000)
B. Electric Starter (Model MGH7000 Only)
Turn the engine switch to the START position (see Figure 17). Hold it there until engine starts. When engine starts, let switch return to the ON position.
IMPORTANT: Do not use electric starter more than five seconds. Starter motor damage may occur. If engine fails to start, release the switch and wait ten seconds. After ten seconds, try starting again.
Note: If engine does not start, check the oil in the crankcase. Add oil as necessary. Be sure engine is on a level surface. See oil alert system, page 9.
5.As engine warms up, slowly move choke lever fully to the right (see Figure 18, page 22). This opens the choke.
HONDA
ON
OFF 
START
Engine |
|
Switch | ENGINE SW |
| CIRCUIT |
| BREAKER |
| ON/push OFF |
Figure 17 - Engine Switch (Model MGH7000 Only)
Continued 21
