OPERATING APPLIANCE
Continued
10.Wait one minute and move switch to the ON position to light burner. Note: AUTO is only functional when using optional remote control accessory.
11.Set flame adjustment knob to any level between HI and LO.
TO TURN OFF GAS
TO APPLIANCE
1.Push switch into OFF position. The pilot will remain lit for normal service.
2.Access control knobs.
3.Depress gas control knob slightly and turn clockwise to OFF. Do not force.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: Remote control accessory must be pur- chased separately (see Accessories, page 17). Follow instructions included with the remote control.
NOTICE: You must light the pilot before using the
After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Flip AUTO/OFF/ON switch to AUTO. Slide the selector switch to the REMOTE position (see Figure 13). Note: The burner may light if
Control Knob
REMOTE
OFF
ON
IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.
ON/OFF SERIES (MODEL GHRCB)
Hold the control button on the
Control Button
Turns Burner
On and Off
Figure 14 - On/Off
WIRING DIAGRAM
When Using Remote
To Remote
Receiver
Thermopile
Piezo Ignitor
Flame
Adjustment
Knob
Selector Switch in REMOTE Position
Figure 13 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
www.desatech.com | 11 |