Installation Instructions for
PCBM-325 conversion kit
Converting from Natural Gas to Propane/LP Gas
For Use When Converting Model (V)P325(B)
Vented Decorative Fireplace
This conversion kit must be installed by a qualified service person.
Read these instructions completely before installing this conversion kit.
Before proceeding, make sure the gas con- trol valve is in the OFF position, all electrical power to the appliance is OFF, and the fire- place is cool to the touch.
CAUTION: The gas supply shall be shut off prior to dis- connecting the electrical power before proceeding with the conversion.
Parts included with this kit:
Part No. | Description | Qty. |
1 | ||
1 | ||
1 | ||
1 | ||
1 | ||
Conversion Label, English | 1 | |
Conversion Label, French | 1 | |
Conversion Information Label | 1 | |
Tools Required:
•7/8" Open End Wrench or Adjustable Wrench
•3/4" Open End Wrench or Adjustable Wrench
•3/8" Deep Socket Drive
•Torx T20 or Slotted Screwdriver
•5/32" Allen Wrench
•#2 Short Phillips Screwdriver
•Thread Sealant (Resistant to Propane/LP )
Accessing Fireplace
You may access burner system through open- ing in front of unit.
1.Remove front glass panels (if installed).
This will keep them from being damaged. To remove, partially open doors. Press up on upper spring clip of one door panel with a screwdriver until outer top pivot pin is free of clip (see Figure 1). Repeat with second door panel. Place glass panels safely out of your work area.
2.Slide open screens and tuck inside outer pockets on firebox.
3.Remove front refractory access panel by lifting up and angling out of firebox open- ing (see Figure 2, page 2).
Depress Spring Clip to | Spring | |
Clip | ||
Release Pivot Pin | ||
|
Fold
Door After
Releasing
Spring Clip
and Slide
Door Out
of Upper
Track
Remove Bottom Pin From
Pivot Plate While Sliding Door
Out of the Upper Track Pivot Plate
Figure 1 - Removing Glass Doors
www.desatech.com
