Desa PCBM-325 Installing Pressure Regulator Assembly, Removing Mounting Screws, Instruction Plate

gas control valve conversion

Convert gas control valve by changing out the valve regulator portion of gas valve.

1.Using a TORX T20 or slotted screwdriver, remove and discard three mounting screws, pressure regulator tower, and diaphragm/spring components (see Fig- ure 5).

2.Insure rubber gasket is properly posi- tioned on new pressure regulator as- sembly. Install new pressure regulator assembly to valve using new mounting screws supplied with kit. Tighten screws securely (approximately 25 in-lbs.) See

Figure 6.

3.Install the identification label enclosed with gas valve regulator to valve body where it can easily be seen (see Figure 6).

Mounting

Screws

Pressure

Regulator

Tower

Diaphragm/

Spring

Components

	O
	FF
N	P
O	TOLI

Mounting Screws

	O
	FF
N	P
O	TOLI

Rubber Gasket

Identification

Label

Figure 6 - Installing Pressure Regulator

Assembly

Conversion labeling and placement

1.Apply the English and French conversion labels over the top of existing certification labels (see Figure 7). Existing certification labels are located on the lighting instruc- tion plate inside the gas valve compart- ment area. With permanent ink, print the previous model number on the label in the space provided (see Figure 8, page 4).

French This

Side

English This

Side

Lighting

Instruction

Plate

Figure 5 - Removing Mounting Screws,	Figure 7 - Applying English and French
	Conversion Labels Over Existing
Pressure Regulator Tower, and
	Certification Labels on Lighting
Diaphragm/Spring Components
	Instruction Plate

108805-01Cwww.desatech.com