SAFETY INFORMATION
Continued
14.Keep heater at least 6 feet (1.8 m) from pro- pane tank(s). Do not point heater at propane tank(s) within 20 feet (6 m).
15.Keep propane tank(s) below 100° F (38˚ C).
16.Check heater for damage before each use. Do not use a damaged heater.
17.Check hose before each use of heater. If highly worn or cut, replace before using heater.
18.Do not alter heater. Keep heater in its original state.
19.Do not use heater if altered.
20.Locate heater on stable and level surface if heater is hot or operating.
21.Not intended for use on finished floors.
22.Never block air inlet (rear) or air outlet (front) of heater.
23.Keep heater away from strong drafts, water spray, rain or dripping water.
24.Do not leave heater unattended.
25.Keep children and animals away from heater.
26.Never move, handle or service a hot, operating or
27.To prevent injury, wear gloves when handling heater.
28.Never attach duct work to heater.
29.Turn off propane supply and unplug heater when not in use.
30.Use only original replacement parts. This heater must use
UNPACKING
1.Remove all packing items applied to heater for shipment. Keep plastic cover caps (attached to inlet connector and hose/regulator assembly) for storage.
2.Remove all items from carton.
3.Check all items for shipping damage. If heater is damaged, promptly inform dealer where you bought heater.
PRODUCT
IDENTIFICATION
Hot Air Outlet | Shell |
(Front) |
|
Handle
Motor
Piezo
Ignitor
Button
Automatic Control
Valve Button
Hose/Regulator | Power | |
Assembly | ||
Cord | ||
|
Figure 1 - 30,000 Btu/Hr Model
THEORY OF OPERATION
The Fuel System: The hose/regulator assembly attaches to the propane gas supply. This provides fuel to the heater.
The Air System: The motor turns the fan. The fan pushes air into and around the combustion chamber. This air is heated and provides a stream of clean, hot air.
The Ignition System: The piezo ignitor lights the burner.
The Automatic Control System: This system causes the heater to shut down if the flame goes out.
Clean Heated |
|
|
Air Out (Front) | Fan | Motor |
|
| |
|
| Cool |
|
| Air In |
|
| (Back) |
Combustion |
|
|
Chamber |
|
|
Air For Combustion | Air For Heating | |
| Hose/Regulator | |
| Assembly | |
Figure 2 - Cross Section Operational View |
www.desatech.com | 3 |