TROUBLESHOOTING
WARNING: Never service heater while it is plugged in, connected to propane supply, operating or hot. Severe burns and electrical shock can occur.
OBSERVED FAULT | POSSIBLE CAUSE | REMEDY | ||
|
|
|
|
|
Fan does not turn when heater is | 1. | No electrical power to heater | 1. | Check voltage to electrical |
plugged in |
|
|
| outlet. If voltage is good, check |
|
|
|
| heater power cord for breaks |
| 2. | Fan hitting inside of heater | 2. | Adjust motor/fan mount to |
|
| shell |
| keep fan from hitting inside of |
|
|
|
| heater shell. Bend fan mount |
|
|
|
| if necessary |
| 3. | Fan blades bent | 3. | Replace fan. See Fan, page 8 |
| 4. | Defective motor | 4. | Replace motor |
|
|
|
|
|
Heater will not ignite | 1. | User did not follow installa- | 1. | Repeat installation and operation |
|
| tion or operation instructions |
| instructions. See Installation, |
|
| properly |
| page 4 and Operation, page 5 |
| 2. | No spark at ignitor. To test for | 2. | A) Check ignitor wire. Tighten |
|
| spark, follow step 8 under Ig- |
| or reattach loose ignitor wire. |
|
| nitor, page 9. If you see spark |
| B) Assure gap between ignitor |
|
| at ignitor, have heater serviced |
| electrode and target plate is |
|
| by qualified service person. If |
| 0.17" (4.3 mm). Do not bend |
|
| no spark seen: |
| electrode. Doing so may cause |
|
| A) Loose or disconnected |
| it to break |
|
| ignitor wire |
| C) Tighten nut holding piezo |
|
| B) Wrong spark gap |
| ignitor to base of heater |
|
| C) Piezo ignitor loose |
| D) Replace ignitor electrode. |
|
| D) Bad ignitor electrode |
| See Ignitor, page 9 |
Heater shuts down while run- ning
WARNING: Use only in areas free of high dust content.
1.Propane supply may be inad- equate
2.High surrounding air tem- perature causing thermal limit device to shut down heater.
3.Restricted air flow
4.Damaged fan
5.Excessive dust or debris in surrounding area
1.A) Refill tank
B)Provide additional and/or larger tanks. See Propane Supply, page 4
2.This can happen when running heater in temperatures above 85° F (29˚ C). Run heater in cooler temperatures
3.Check heater inlet and outlet. Remove any obstructions
4.Replace fan. See Fan, page 8
5.Clean heater. See Mainte- nance, page 6
TECHNICAL SERVICE
You may have further questions about this heater. If so, contact DESA Heating Productsʼ Technical Service Department at
You can also visit DESA Heating ProductsʼTechni- cal Service web site at www.desatech.com.
ACCESSORY
Purchase accessories and parts from your near- est dealer or service center. If your dealer or service center can not supply an accessory or part, call DESA Industriesʼ Parts Department at
LPA4020 - Fuel Gas Connector
Connects regulator to all standard propane tanks. U.L. and AGA
www.desatech.com | 7 |