OWNER’S MANUAL
SERVICE
PROCEDURES
WARNING: Never service heater while it is plugged in, con- nected to propane supply, oper- ating, or hot. Severe burns and electrical shock can occur.
MOTOR
1.While on heaters side Remove base tray.
2.Access ground screw through underside of heater base. Remove ground screw. Disconnect the green motor wire and the green power cord wire from underside of shell (see Figure 5).
3.Remove black and white motor wires from terminal board (see Figure 5).
4.Carefully push motor wires through hole in bottom of shell.
5.Remove screws holding motor mount to shell. Use
|
| Transformer |
| Ground | Green Lead |
|
| |
| Screw |
|
Motor |
| Power |
| Cord | |
Green |
| |
| Green | |
Lead |
| |
| Lead | |
|
|
Terminal
Board
Figure 5 - Location of Ground Screw
Motor |
| |
Mount |
| |
Screw | Fan | |
| ||
| Guard | |
Hole in | Motor | |
Mount | ||
Shell | ||
| ||
for Wires |
|
Figure 6 - Removing Motor, Motor Mount, and Fan Guard from Heater
6.Carefully pull motor and fan out of shell.
IMPORTANT: Be careful not to damage fan. Do not set motor and fan down with the weight resting on fan. This could damage fan pitch.
7.Use hex wrench to loosen setscrew which holds fan to motor shaft.
8.Remove fan. Be careful not to damage the fan blade pitch.
9.Use nut driver to remove two nuts that attach motor to motor mount.
10.Discard old motor.
11.Attach motor to motor mount with two nuts. Tighten nuts firmly.
12.Replace fan on motor shaft. Make sure set screw contacts flat surface on motor shaft.
13.Tighten set screw firmly
14.Carefully route motor wires through hole in shell (see Figure 7). Place motor, motor mount, and fan guard into rear of heater shell.
15.Insert screws through heater shell and into motor mount. Tighten screws firmly.
16.Turn heater on its side to access opening in bottom of base. Connect green wires from motor, transformer, and power cord to heater shell using ground nut (see Figure 5).
17.Attach black and white wires to terminal board (see Wiring Diagram, page 9, for correct locations) .
18.Replace base tray.
Hole in
Shell
Figure 7 - Replacing Motor, Motor Mount, and Fan Guard into Heater
FAN
1Remove motor, motor mount, and fan (see Motor, steps 1 through 8) .
2.Clean fan using soft cloth moistened with kerosene or solvent.
3.Dry fan thoroughly.
4.Replace fan on motor shaft. Make sure setscrew is touching back of flat surface on motor shaft (see Figure 8).
5.Place setscrew on flat of shaft. Tighten setscrew firmly
6.Place motor, motor mount, and fan guard into rear of heater shell (see Motor, steps 14 through 18).
Fan
Setscrew
Motor shaft
FAN |
Figure 8 - Fan, Motor Shaft, and Setscrew Location
Fan
Hub
Motor
Setscrew
FAN CROSS SECTION |
Figure 9 - Fan Cross Section
Continued
105342 | 7 |