SERVICE PROCEDURES
Upper Shell Removal
1.Remove screws along each side of heater using 5/16"
2.Lift upper shell off.
3.Remove fan guard.
Fan
IMPORTANT: Remove fan from motor shaft before removing motor from heater. The weight of the motor resting on the fan could damage the fan pitch.
1.Remove upper shell (see above).
2.Use 1/8" Allen wrench to loosen setscrew which holds fan to motor shaft.
3.Slip fan off motor shaft.
4.Clean fan using a soft cloth moistened with kerosene or solvent.
5.Dry fan thoroughly.
6.Replace fan on motor shaft. Place fan hub flush with end of motor shaft (see Figure 8).
7.Place setscrew on flat of shaft. Tighten setscrew firmly
8.Replace fan guard and upper shell.
10
!WARNING
Never service heater while it is plugged in, operating, or hot. Severe burns and electrical shock can occur.
Upper
Shell
Fan Guard
125 SHELLFigureREMOVAL6 - Upper Shell RemovalPFA/P 050
Setscrew | Fan |
Motor
Shaft
Figure 7 - Fan, Motor Shaft, and Setscrew Location
Fan
Flush
Motor
Shaft
Setscrew
Figure 8 - Fan Cross Section
