Stove Cavity Assembly

INSTALLATION

INSTALLATION

Continued

1.Lift off corrugated box enclosing stove body crating.

2.Remove all screws fastening the wood frame enclosure. Spread wood frame open and lift away from plastic-bagged stove body. The bottom pieces of pallet wood will remain bolted to the stove body.

3.Remove plastic bag from stove body.

4.Remove back panel from stove (see Figure 5). Use an adjust- able wrench or a 10 mm socket. Remove six (6) bolts and wash- ers. Keep bolts and washers to reattach back panel later.

5.Remove all contents from inside stove cavity. Contents include:

(1) - Stove bottom

(4)- Legs (Amity™ and Townsend™ models include leg lev- eler bolts)

(1)- Bottom door

(1) - Top grate

(1)- Hardware kit bag with fasteners

6.Carefully lay stove body on back to attach bottom components to stove body (see Figure 6). Rest stove on drop cloth or blan- ket to avoid scratching stove edges.

7.Remove remaining pallet wood attached to bottom of stove body (see Figure 7). Use an adjustable wrench to remove bolts.

Bolt

Back Stove

Panel

Product

Identification

Label

Figure 5 - Removing Back Panel

Front

Bolt	Pallet
	Wood

Pallet	Bottom Of
Wood	Bottom Of
	Stove Unit

Figure 7 - Removing Pallet Wood From The Bottom of The Stove

Amity™ and Townsend™ Models

8.Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figures 8 and 9). Use an adjustable wrench or a 12mm socket.

9.Fasten stove bottom to stove with four (4) M6 x 1 - 25mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figure 8 and Fig- ure 10, page 9). Use an adjustable wrench or a 10mm socket.

Door Hinge Step		Door Catch Bolt
Door Hinge Step	Front	With Adjustable
Bolt Hole	Front	Hex Nuts Hole
Bolt Hole		Hex Nuts Hole
Leg		Leg Hole
Hole
	Holes for	Bottom Of
	Holes for	Stove Unit
	Stove	Stove Unit
	Stove
	Bottom	Leg Hole
Leg		Leg Hole
Hole