Fireplace Installation
Continued
Installing
1.Remove battery cover on back of remote control unit.
2.Attach terminal wires to a
3.Replace battery cover onto remote control unit.
Battery Cover | Remote Control Unit |
|
Terminal
Wires
Battery
Battery
Figure 40 - Installing Battery in Hand-
Held Remote Control Unit
Removing Louver Panels
Remove top and bottom louver panels by simultaneously pulling both top end spring latches towards center of appliance until they are disengaged from locating holes (see Figure 41). Repeat for bottom spring latches and pull louvers outward. To install or replace items removed, simply reverse procedures above.
Louver
Panel
Spring
Latch
Figure 41 - Removing Louver Panel
Removing Glass Door
If replacement of glass is necessary, entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape remaining fragments onto frame.
Removing/Replacing Glass Door
CAUTION: Do not operate thisfireplacewithabrokenglass door panel or without the glass door panel securely in place. For replacement part information see Replacement Parts, page 37.
1.Remove screen assembly by pushing rod either left or right, then down and forward to remove screen/rod assembly from firebox. Set assembly aside.
2.Lift up on latches to unlock. There are two on top of firebox and two below firebox that hold glass door in place (see Figure 42).
3.While holding glass door to prevent it from falling and causing injury, remove 5 screws from hinge located on left side of door frame assembly (see Figure 42).
CAUTION: Wear gloves and safety glasses while handling or removing broken glass. Do not remove if glass is hot. Keep children and pets away from glass.
Unlock 
Lock
Latch
WARNING: If fireplace has | Screw |
been running, turn off and un- |
|
plugfireplace.Letcoolbeforere- | Hinge |
moving glass door or louvers. |
Glass Frame
Assembly
Figure 42 - Removing/Replacing Glass Door
www.desatech.com | 25 |