Installing Logs, Installation, Continued

INSTALLATION

Installing Optional Remote Accessories (Cont.) Installing Logs

INSTALLATION

Continued

8.	Install remote receiver into receiver bracket using pads and
	push button clips provided with receiver (see Figure 20).
9.	Connect wires to control valve at the TPTH and TH locations
	as shown in Figure 21. Note: Make sure excess wire does not
	interfere with burner or pilot.
10.	If heater was removed from fireplace before installation of re-
	mote accessory, see Installing Heater Base Assembly on pages
	10 and 11 to reinstall heater into fireplace. Test gas connection

Installing 9-Volt Battery (Not Included) in Hand- Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to the battery. Place battery into the bat- tery housing.

3.Replace battery cover onto remote control unit.

for leaks (see Checking Gas Connections, pages 11 and 12).

11. If logs were removed from heater for install remote accessory,

replace logs (see Installing Logs, pages 14 and 15).

Terminal Wires

Battery Cover

9-Volt

Battery

9-Volt Battery

Battery Housing

Remote Control Unit

		Clip
		Terminal
		Wires
Push Button	Bracket	Pad
Clips
Figure 20 - Installing Remote Receiver
White
Wire From
Receiver		Control
		Valve
	Red Wire From
	Receiver
Figure 21 - Connecting Wires

Installing Batteries for Remote Receiver and Hand Held Remote Control

Two 9-volt alkaline batteries (not included) are required to operate this heater with the wireless hand-held remote control set. One battery must be installed in the receiver and one in the hand-held remote control unit. Note: Only use alkaline batteries.

Installing 9-Volt Battery in Receiver

1.Locate back of receiver behind receiver bracket mounted on base assembly.

2.Locate the battery clip mounted on the back of the receiver (see Figure 20).

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Figure 22 - Installing Battery in Hand-Held Remote Control Unit (CGHRCB Series)

9-Volt	Terminal	Remote
9-Volt	Wires	Remote
Battery		Control Unit
		Battery Cover
Battery
Housing

Figure 23 - Installing Battery in Hand-Held Remote Control Unit (CGHRCTB Series)

INSTALLING LOGS

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs accord- ing to the log installation instructions in this manual. Flames contacting logs will create soot.