FIREPLACE INSTALLATION
Removing/Replacing Glass Door (Cont.) Installing Lava Rock and Glowing Embers
21
FIREPLACE INSTALLATION
Continued
Removing Glass Door
If replacement of glass is necessary, the entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape the remaining fragments onto the frame.
1.Remove screen assembly by pushing the rod either left or right and then down and forward to remove screen/rod assembly from the firebox. Set assembly aside.
2.Lift up on latches to unlock. There are two on top of firebox and two below firebox that hold glass door in place (see Figure 37).
3.While holding glass door to prevent it from falling and causing injury, remove the five screws from the hinge located on the left side of door frame assembly (see Figure 37).
4.Remount the new frame at the hinge with five new screws before closing door. This will ensure seating of the gasket.
5.Close glass door frame. Lock latches by placing the bar under the tab on door and pushing down and back on latch (see Figure 37).
6.Replace screen/rod assembly by reversing step 1.
7.Replace louvers by reversing procedure under Removing Lou- ver Panels, page 20.
Latch | Unlock | Lock |
|
|
Screw
Hinge 
Glass Frame
Assembly
Figure 37 - Removing/Replacing Glass Door
Cleaning Glass Door
See Cleaning and Maintenance on page 25.
INSTALLING LAVA ROCK AND GLOWING EMBERS
It is very important to keep logs exactly as installed. Do not modify logs. Only use log set designed for this fireplace.
WARNING: Logs are unitized and are not attached to the burner. Do not handle log assembly by top logs. Always pick up by the bottom.
Open louvers, remove screen, unlock door latches and open glass door. See Removing Glass Door, steps 1 and 2.
1.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the exposed front section of the burner (see Figure 43). This will create the glow- ing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
2.Pour lava rock onto plenum but not onto flat burner. It is not necessary to use all of the lava rock provided.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner will cause per- formance problems.
3.Close glass door, lock door latches, replace screen and close louvers (see Removing Glass Door, steps 5 through 7).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
Andiron | Plenum |
|
Ember Material
Figure 38 - Placing Ember Material on Burner
www.desatech.com |
