OWNER’S MANUAL
INSPECTING
BURNER
Check pilot flame pattern and burner flame pattern often.
PILOT FLAME PATTERN
Figure 30 shows a correct pilot flame pattern. Figure 31 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touch- ing the thermocouple. This will cause the thermocouple to cool. When the thermo- couple cools, the fireplace will shut down.
If pilot flame pattern is incorrect, as shown in Figure 31
•turn fireplace off (seeTo Turn Off Gas to Appliance, page 18)
•seeTroubleshooting, pages 20 through 22
Thermocouple
Pilot Burner
Figure 30 - Correct Pilot Flame Pattern (Actual Pilot May Vary From Illustration)
Thermocouple
Pilot Burner
BURNER FLAME PATTERN
Figure 32 shows a correct burner flame pattern. Figure 33 shows an incorrect burner flame pattern. The incorrect burner flame pattern shows yellow tipping of the flame. It also shows the flame higher than one inch above the log.
Note: When using the fireplace the first time, the flame will be yellow for approxi- mately one hour until the log cures.
WARNING: If yellow tipping occurs, your fireplace could pro- duce increased levels of carbon monoxide. If burner flame pattern shows yellow tipping, follow in- structions at bottom of this page.
NOTICE: Do not mistake orange flames with yellow tipping. Dirt or other fine particles enter the fireplace and burn causing brief patches of orange flame.
If burner flame pattern is incorrect, as shown in Figure 33
•turn fireplace off (seeTo Turn Off Gas to Appliance, page 18)
•seeTroubleshooting, pages 20 through 22
Top of Flame About
One Inch Above Logs
Figure 32 - Correct Burner Flame Pattern
Yellow Tipping
Figure 31 - Incorrect Pilot Flame Pattern |
|
(Actual Pilot May Vary From Illustration) | Figure 33 - Incorrect Burner Flame Pattern |
|
104060 | 19 |
