VANGUARD VP10T
PROPANE/LP GAS HEATER
INSTALLING TO
LOCATING HEATER | CEILING |
WALL
NOTICE: A qualified service per- son must install heater. Follow all local codes.
CHECK GAS TYPE
Use only propane/LP gas. If your gas supply is not propane/LP, do not install heater. Call dealer where you bought heater for proper type heater.
INSTALLATION ITEMS
Before installing heater, make sure you have
This heater is designed to be mounted on a wall.
WARNING: Maintain the mini- mum clearances shown in Figure
4.If you can, provide greater clear- ances from floor, ceiling, and joining wall.
WARNING: Never install the heater
• | in a bathroom |
• in a recreational vehicle | |
• | where curtains, furniture, |
36"
Minimum
8" Minimum
From Sides Of
Heater
Right
LeftSide
Side
3"Minimum To
the items listed below.
• | external regulator (supplied by in- |
| staller, see page 8) |
• | piping (check local codes) |
clothing, or other flammable |
objects are less than 36 inches |
from the front, top, or sides of |
the heater |
• as a fireplace insert |
FLOOR
Top Surface
Of Carpeting,
Tile Or Other Combustible
Material
• sealant (resistant to propane/LP gas) | |
• | manual shutoff valve * |
• | ground joint union |
• | test gauge connection * (see Figure |
| 13, page 8) |
• | sediment trap |
• | tee joint |
• | pipe wrench |
* An A.G.A. | |
valve with 1/8" NPT tap is an acceptable | |
alternative to test gauge connection. The | |
optional A.G.A. | |
shutoff valve can be purchased from your | |
dealer. See Accessory, page 15. |
• | in high traffic areas |
• | in windy or drafty areas |
CAUTION: This heater cre- ates warm air currents. These currents move heat to wall sur- faces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities in the air (such as tobacco smoke) exist, may discolor walls.
IMPORTANT:
CAUTION: If you install the heater in a home garage
•heater pilot and burner must be at least 18 inches above floor
•locate heater where moving ve- hicle will not hit it
For convenience and efficiency, install heater
•where there is easy access for opera- tion, inspection, and service
•in coldest part of room
Figure 4 - Mounting Clearances As Viewed From Front of Heater
INSTALLING HEATER TO WALL
Marking Screw Locations
1.Determine where you will locate heater.
WARNING: Maintain minimum clearances shown in Figure 5. If you can, provide greater clear- ances from floor and joining wall.
2.Mark two mounting screw locations on wall (see Figure 5).
10 7/8"7 3/4"
Minimum To
Maintain 8"
Clearance
From Wall
WALL | Mounting | 20 1/4" | |
| |||
| Screw | Minimum | |
JOINING | Locations | To | |
| Maintain 3" | ||
|
| ||
|
| Clearance | |
|
| From | Floor |
|
|
|
|
FLOOR
Figure 5 - Mounting Screw Locations
6 | 102489 |