22
FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL42DA(SA), BL42DHA(SA)
FIREPLACE INSTALLATION
Continued
INSTALLING OPTIONAL BRICK LINER MODELS BL42DA(SA), BL42DHA(SA)
WARNING: If fireplace has been running, turn off and unplug fireplace. Let cool before installing brick liner.
This brick liner kit is optional. You may purchase brick liner from your local retailer or see Accessories, page 37.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Exces- sive force will break brick panels.
1.Remove top and bottom louvers to allow access to door latches.
2.Remove screen, unlock door latches and open glass door. See Removing/Replacing Glass Door, steps 1 and 2, page 21.
3.If installing brick liner in new fireplace, go to step 4. If install- ing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.
4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.
5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 38).
6.Install left side brick panel by sliding it between the grate and the side of the firebox (see Figure 39).
7.Install the right brick panel using the same method described in step 6 for left brick panel.
8.Replace deflector shield using screws removed in step 4.
9.Install logs, lava rock and glowing embers. See Installing Logs, Lava Rock and Glowing Embers, pages 22 and 23.
Rear Brick Panel
Figure 38 - Installing Rear Brick Panel
10.Close glass door and lock latches on top and bottom of door and replace screen. See Removing/Replacing Glass Door, steps 5 and 6, page 21.
11.Close top and bottom louvers.
Left Side
Brick Panel
Figure 39 - Installing Left Side and Top Brick Panels
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See Removing/Replacing Glass Door, steps 1 and 2, page 21. Install logs according to instructions for fireplace model numbers.
1.Place log #1 (base log) onto pin on left front side of grate as shown in Figure 40.
1
Figure 40 - Installing Log No. 1
For
.
.com
