Assembling Mantel
IMPORTANT: More than one person is required to lift assembled mantel. Lift mantel by leg assemblies. Lifting by header or mantel top could damage mantel.
Use the following illustrations to assemble mantel. Use only screws provided.
Header #4
Right Leg
Assembly #2
Left Leg
Assembly #3
Header
Assembly
Block
11/4"
Screws
Figure 1 - Installing Header
11/4" Screw | Header #4 |
|
Heat Reflector
Strip #6
Figure 2 - Installing Heat Strip
IMPORTANT: Make sure heat reflector strip is flush against header and spacers are on bottom side. Heat strip should NOT be flush with leg side but should have 1" clearance on both ends.
Mantel
Top #5
Assembly
Blocks
11/4"
Screws
Figure 3 - Installing Top
IMPORTANT: Align mantel top left to right before installing. Back of mantel leg must be flush with back of mantel top before installation.
Right Leg
Assembly #2
Left Leg
Assembly #3
11/4"
Screws
Base #1
Flush
Figure 4 - Installing Mantel Base
IMPORTANT: Align mantel left to right on base before install- ing. Mantel legs must be flush with back of mantel base before installation. Use a tape measure to insure accuracy.
2 | www.desatech.com |