Cisco TelePresence System Codec C90 and Profile 65” Dual using C90

Contents

Introduction

Web interface

Advanced configuration

Password protection

Appendices

Administrator guide

Contact us

Change the user passwords

All users can change their own codec password as described on the previous page.

If you have ADMIN rights, you can change all users’ passwords by performing the following steps:

1.Log in to the web interface with username and password.

2.Go to the Users page.

3.Select the appropriate user from the list.

4.Enter a new password and PIN code.

5.Click Save.

Set a root password

If you log in to the command line interface as root, you can access the codec’s file system.

The root user is disabled by default.

Perform the following steps to activate the root user and set a password:

1.Connect to the codec through the network or the serial data port, using a command line interface (SSH or Telnet).

2.Log in to the codec with the username (admin) and password. You need ADMIN rights.

3.Run the following API command:

systemtools rootsettings on <password>

NOTE: The root password is not the same as the administrator password.

D14635.05 Profile C90 and Codec C90 Administrator Guide TC4.1, February 2011.

72

www.cisco.com

Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.

Page 72
Image 72
Cisco Systems C90 manual Change the user passwords, Set a root password