Cisco TelePresence System Codec C90 and Profile 65” Dual using C90 | Administrator guide |
Contents
Introduction
Web interface
Advanced configuration
Password protection
Appendices
Contact us
SIP Profile [1..1] Type
Enables SIP extensions and special behaviour for a vendor or provider.
Requires user role: ADMIN
Value space: <Standard/Alcatel/Avaya/Cisco/Microsoft/Nortel/Experimental/ Siemens>
Standard: Should be used when registering to standard SIP proxy like OpenSer.
Alcatel: Must be used when registering to a
Avaya: Must be used when registering to a Avaya Communication Manager.
Cisco: Must be used when registering to a Cisco CallManager version 5 or later.
Microsoft: Must be used when registering to a Microsoft LCS or OCS server.
Nortel: Must be used when registering to a Nortel MCS 5100 or MCS 5200 PBX.
Experimental: Can be used if auto is not working. NOTE: This mode is for testing purposes only.
Example: SIP Profile 1 Type: Standard
The Standby settings
Standby Control
Determine whether the system should go into standby mode or not.
Requires user role: ADMIN
Value space: <On/Off>
On: Enter standby mode when the Standby Delay has timed out. NOTE: Requires the Standby Delay to be set to an appropriate value.
Off:The system will not enter standby mode.
Example: Standby Control: On
Standby Delay
Define how long (in minutes) the system shall be in idle mode before it goes into standby mode. NOTE: Requires the Standby Control to be enabled.
SIP Profile [1..1] URI
The SIP URI or number is used to address the system. This is the URI that is registered and used by the SIP services to route inbound calls to the system. A Uniform Resource Identifier (URI) is a compact string of characters used to identify or name a resource.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: Compact string with a maximum of 255 characters.
Example: SIP Profile 1 URI: "sip:firstname.lastname@company.com"
Requires user role: ADMIN
Value space: <1..480>
Range: Select a value from 1 to 480 minutes.
Example: Standby Delay: 10
Standby BootAction
Define the camera position after a restart of the codec.
Requires user role: ADMIN
Value space: <None/Preset1/Preset2/Preset3/Preset4/Preset5/Preset6/Preset7/ Preset8/Preset9/Preset10/Preset11/Preset12/Preset13/Preset14/Preset15/ RestoreCameraPosition/DefaultCameraPosition>
None: No action.
Preset1 to Preset15: After a reboot the camera position will be set to the position defined by the selected preset.
RestoreCameraPosition: After a reboot the camera position will be set to the position it had before the last boot.
DefaultCameraPosition: After a reboot the camera position will be set to the factory default position.
Example: Standby BootAction: DefaultCameraPosition
D14635.05 Profile C90 and Codec C90 Administrator Guide TC4.1, February 2011. | 56 | www.cisco.com |
Copyright © |
