Cisco TelePresence System Codec C90 and Profile 65” Dual using C90

Administrator guide

Contents

Introduction

Web interface

Advanced configuration

Password protection

Appendices

Contact us

About monitors when you have a Codec C90

The main monitor

The main monitor can be connected to any of the video outputs HDMI 1 (the default connector for the main monitor) HDMI 3 (the default connector for the dual monitor), DVI-I 2 or DVI-I 4.

Connecting to HDMI 1

The HDMI 1 output is, by default, defined as the main monitor connector. When you connect the main monitor to this output the menu and icons (OSD - on screen display) will show on this monitor.

Connecting to DVI-I 2, DVI-I 4, HDMI 3

When connecting the main monitor to the DVI–I 2, DVI–I 4 or HDMI 3 output, you must move the OSD to this output.

If you cannot see any menu on screen you must run a key sequence on the remote control. The menu on screen, icons and other information (OSD - on screen display) will be moved to the selected output. At the same time, the resolution will be set to the default value, which is 1024x768@60Hz for DVI and 1280x720@60Hz for HDMI.

The video outputs at Codec C90

DVI-I 4

HDMI 3

(the default connector for the dual monitor)

DVI-I 2

HDMI 1

(the default connector for the main monitor)

Moving the OSD using the remote control

If the main monitor is connected to DVI-I 2 video output you must run the following shortcut or key sequence on the remote control.

Disconnect * # * # 0 x # x=1 (HDMI 1) x=2 (DVI–I 2) x=3 (HDMI 3) x=4 (DVI–I 4)

Example: Set DVI-I 2 as the OSD output.

* # * # 0 2 #

Moving the OSD using the web interface

Go to the Advanced Configuration page and navigate to Video > OSD > Output and select the video output connector for the main mointor.

Moving the OSD using API commands

You can also set the resolution and the OSD output by setting up a serial port connection and run API commands. See the API Guide for the codec for information about API commands.

Dual monitors

When you want to run a dual monitor setup, connect the second monitor to video output HDMI 3 on the codec.

Dual monitor configuration

Go to Advanced configuration (menu on screen or web interface) to set the monitor to dual:

1.Navigate to Video > Output > Monitor and set the Monitor to Dual.

D14635.05 Profile C90 and Codec C90 Administrator Guide TC4.1, February 2011.

75

www.cisco.com

Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.

Page 75
Image 75
Cisco Systems manual About monitors when you have a Codec C90, Main monitor, # * # 0 2 #, Dual monitors