2.Assemble left side (#4) and left leg (#5) as described in step 1.
3.Attach 6 brackets to base (#1) at threaded hole locations us- ing 1/2" screws leaving screws loose. Face brackets toward outside.
4.Place right side/leg assembly on base and align threaded holes with brackets. Start 1/2" screws through brackets into threaded holes in side/leg assembly. Back of side/leg assembly should be flush with back of base. Assure alignment is correct and spaces are at a minimum. Leave screws slightly loose.
5.Assemble left side/leg assembly to base following step #4.
| Tongue on |
| Leg Side |
Leg Side (#4) 1/2" Screw |
|
Bracket |
|
| Leg Front (#5) |
| Groove in |
| Leg Front |
Groove in |
|
Leg Front |
|
Leg Front (#3) |
|
Tongue on |
|
Leg Side | Leg Side (#2) |
|
Figure 1 - Right and Left Leg Assemblies
1.Using 1/2" screws, secure brackets to two threaded holes at both ends of header (#6). Turn brackets to the outside.
2.Place header (#6) into position on top of leg assemblies with arrow pointing up. Bottom of header will slide in behind upper portion of leg front panels and rest on shoulders (see Figure
3). Align bracket holes with threaded inserts in leg assemblies.
Using four 1/2" screws through brackets, attach header to leg assemblies. Leave screws loose.
3.Be sure alignment is correct and spaces are at a minimum having at least one person holding panels securely. Tighten all screws with Allen wrench provided.
Header (#6)
Bracket | Threaded |
1/2" Screw | Insert |
|
Shoulder of
Leg Front
Panel
Right | Figure 3 - Attaching Header |
| |
Side/Leg | Mantel Top Assembly |
Assembly |
Base (#1)
Bracket
1/2" Screw
Figure 2 - Leg Assembly to Base
Place mantel top (#7) on mantel assembly. Align back of top with back of sides. Using seven 1 1/4" screws with washers, place two in each mantel side assembly and three in the header (see Figure 4, page 3). Make sure all pieces are aligned properly and tighten all seven screws.
www.desatech.com |